Emerson PACMotion VFD Series - Mounting the Drive - IP20 Units

GFK-3111A PACMotion VFD AC Variable Speed Drive User Guide 19
Mounting the Drive – IP20 Units
• IP20 Units are intended for installation within a control cabinet.
• When mounting with screws:
o Using the drive as a template, or the dimensions shown above, mark the locations for drilling.
o Ensure that when mounting locations are drilled, the dust from drilling does not enter the drive.
o Mount the drive to the cabinet backplate using suitable mounting screws.
o Position the drive, and tighten the mounting screws securely.
• When Din Rail Mounting (Frame Size 2 Only):
o Locate the DIN rail mounting slot on the rear of the drive onto the top of the DIN rail rst.
o Press the bottom of the drive onto the DIN rail until the lower clip attaches to the DIN rail.
o If necessary, use a suitable at blade screw driver to pull the DIN rail clip down to allow the drive to
mount securely on the rail.
o To remove the drive from the DIN rail, use a suitable at blade screwdriver to pull the release tab
downwards, and lift the bottom of the drive away from the rail rst.