Emerson PACMotion VFD Series

To Next Page

To Previous Page

GFK-3111A PACMotion VFD AC Variable Speed Drive User Guide 73

Par. Function Setting Range

Default

Notes

P9-01 Enable Input source These parameters allow the user to directly select the source of the various

command points. Parameters are only adjustable if P1-13 = 0. This allows

complete exibility over the drive control functions, and interaction with the

internal Function Block programming environment.

P9-02 Fast stop Input source

P9-03 Run forward Input source

P9-04 Run reverse Input source

P9-05 Latch function enable 0 OFF 0

1 ON

P9-06 Reverse Input source See above

P9-07 Reset Input source

P9-08 External trip Input source

P9-09 Terminal control select source

P9-10 Speed reference 1 In combination with P9-18 – P9-20, allow selection of several speed reference

sources for common applications.

P9-11 Speed reference 2

P9-12 Speed reference 3

P9-13 Speed reference 4

P9-14 Speed reference 5

P9-15 Speed reference 6

P9-16 Speed reference 7

P9-17 Speed reference 8

P9-18 Speed ref.select bit 0 source See above

P9-19 Speed ref.select bit 1 source

P9-20 Speed ref.select bit 2 source

P9-21 Preset speed select bit 0 source

P9-22 Preset speed select bit 1 source

P9-23 Preset speed select bit 2 source

P9-24 Accel. ramp select bit 0 source

P9-25 Accel. ramp select bit 1 source

P9-26 Decel. ramp select bit 0 source

P9-27 Decel. ramp select bit 1 source

P9-28 Motorised pot up input source

P9-29 Motorised pot up down source

P9-30

Speed limit forward input source

P9-31

Speed limit reverse input source

P9-33 Analog output AO1 source 0 Dened by P2-11 0 These parameters allow the

user to override the normal

parameter control source

for the associated function,

allowing interaction with

the internal Function Block

programming environment.