6-33
Setup Device Info
This screen sets the device information for a transmitter.
NOTE
Since the Compensated Flow procedure automatically includes these
settings as the device information for either a configuration file, or as
the device information sent to the transmitter, be sure that this screen
is set correctly before performing the Compensated Flow procedure.
S
etup EA Default Units U.S. Units SI/Metric Units
These menu selections set the default units for the EA as either U.S.
Units, or SI/Metric units.
The selected units will be automatically selected during the next time
you restart the EA software, or the next time you select F
ile, New
Config.
This selection does not change the units for a flow configuration that
has already been saved to a file or sent to a transmitter.
Figure 6-29.
Device Info Screen.
Figure 6-30.
Device Info Screen.
To Next Page
Loading...
