Emerson Rosemount 1195 - MINIMUM EQUIPMENT AND SOFTWARE; INSTALLATION PROCEDURE

Rosemount Model 1195/ProPlate/Mass ProPlate
6-2
MINIMUM EQUIPMENT
AND SOFTWARE
• DOS-based 386 computer or above
• 640K base RAM with 8 MB extended
• Mouse or other pointing device
• Color computer display
• Mass ProPlate Engineering Assistant Software,
HART modem, set of modem cables
• MS DOS
®
3.1 or higher
• Microsoft
®
Windows
®
3.1, Windows for
Workgroups 3.11, or Windows 95
NOTE
The EA software does not work with Windows NT, Windows 98, or
Windows 2000.
The EA software does not work with revision 4.04.9. of Phoenix BIOS. We do
not recommend installing the Engineering Assistant on computers that use
this BIOS.
INSTALLATION
PROCEDURE
This procedure assumes that both DOS and Windows are already installed.
NOTE
In this manual, UHWXUQ indicates to press the return or enter key.
1. Power on the computer.
2. After completion of boot-up procedures, verify that the computer
is in Microsoft Windows. If the computer is at the DOS prompt
(for example, C:\), type win
UHWXUQ to open Windows.
3. Insert the floppy disk containing the Engineering Assistant
Software into the personal computer disk drive.
4. Select F
ile, then select Run to display the Run window. Depending on
the
disk drive, enter either a: setup or b: setup, then select OK to display
the following screen: