133
Product Certifications
Product Certifications
March 2016
Reference Manual
00809-0100-4772, Rev FA
Appendix B Product Certifications
Product certifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 133
European directive information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 133
ATEX Directive . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 133
European Pressure Equipment Directive (PED) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 133
Hazardous location certifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 133
B.1 Product certifications
B.1.1 Approved manufacturing locations
Emerson—Eden Prairie, Minnesota, USA
Emerson Process Management BV - Ede, The Netherlands
Emerson Process Management Flow Technologies Co., Ltd -
Nanjing, Jiangsu Province, P.R. China
SC Emerson SRL - Cluj, Romania
B.1.2 Flameproof enclosure Ex d protection
type in accordance with IEC 60079-1,
EN 60079-1
Transmitters with flameproof enclosure type protection
shall only be opened when power is removed.
Closing of entries in the device must be carried out using
the appropriate Ex d cable gland or blanking plug. Unless
otherwise marked on housing, the standard conduit entry
thread forms are 1/2-14 NPT.
B.1.3 Type n protection type in accordance
with IEC 60079-15, EN60079-15
Closing of entries in the device must be carried out using
the appropriate Ex e or Ex n cable gland and metal blanking
plug or any appropriate ATEX or IECEx approved cable gland
and blanking plug with IP66 rating certified by an EU
approved certification body.
B.2 European directive information
The CE Declaration of Conformity for all applicable
European directives for this product can be found on our
website at EmersonProcess.com/Rosemount
. A hard copy
may be obtained by contacting our local sales office.
B.3 ATEX Directive
Emerson complies with the ATEX Directive.
B.4 European Pressure Equipment
Directive (PED)
B.4.1 Rosemount 8800D Vortex Flowmeter
Line Size 40 mm to
300 mm
Certificate Number 4741-2014-CE-HOU-DNV
0575
Module H Conformity Assessment
Mandatory CE-marking for flowmeters in accordance with
Article 15 of the PED can be found on the flowtube body.
Flowmeter categories I – III use module H for conformity
assessment procedures.
B.4.2 Rosemount 8800D Vortex Flowmeter
Line Size 15 mm and 25 mm
B.4.3 Sound Engineering Practice (SEP)
Flowmeters that are SEP are outside the scope of PED and
cannot be marked for compliance with PED.
B.5 Hazardous location
certifications
To Next Page
Loading...
Need help?
General
