42
Reference Manual
00809-0100-4772, Rev FA
Installation
March 2016
Installation
3.6.8 Transmitter security
After you configure the transmitter, you may want to protect the configuration data from
unwarranted changes. Each transmitter is equipped with a security jumper that can be
positioned ON to prevent the accidental or deliberate change of configuration data. The
jumper is located on the front side of the electronics module and is labeled SECURITY (see
Figure 3-19).
3.6.9 LCD display option
If your electronics are equipped with the LCD display (Option M5), the fieldbus simulate
enable and transmitter security jumpers are located on the face of the indicator as shown in
Figure 3-20.
Figure 3-20. LCD Display Fieldbus Simulate Enable and Transmitter Security Jumpers
3.7 Transmitter configuration
To complete the installation of the flowmeter, configure the software to meet the
requirements of your application. If the flowmeter was pre-configured at the factory, it may
be ready to install. If not, refer to Section 2: Configuration and Operation.
SIMULATE ENABLE
SECURITY
ON
OFF
OFF
ON
To Next Page
Loading...
