54
www.encore-usa.com
WPS: (Push Button Wireless Connection)
Check the box to enable WPS function and uncheck it to disable the WPS function.
WPS Current Status:
If the wireless security (encryption) function of this wireless router is properly set, you’ll see
a ‘Configured’ message here. Otherwise, you’ll see ‘UnConfigured’. Click the “Release
Configuration” can clear the security settings of the 1st SSID.
Self Pin Code:
This is the Push Button Wireless Connection PIN code of the wireless router. You may
need this information when connecting to other WPS-enabled wireless devices.
SSID:
This is the network broadcast name (SSID) of the router.
Authentication Mode:
It shows the active authentication mode for the wireless connection.
Passphrase Key:
It shows the passphrase key that is randomly generated by the wireless router during the
WPS process. You may need this information when using a device which doesn’t support
WPS.
Interface:
If device is set to repeater mode, you can choose “Client” interface to connect with other
AP by using WPS, otherwise you may choose “AP” interface to do WPS with other
clients.
WPS via Push Button:
Press the button to start the WPS process. The router will wait for the WPS request from
the wireless devices within 2 minutes.
WPS via PIN:
You can fill-in the PIN code of the wireless device and press the button to start the WPS
process. The router will wait for the WPS request from the wireless device within 2
minutes.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
