64
www.encore-usa.com
Add Port Mapping
Fill in the "Local IP", “Protocol”, “Port Range” and "Description" of the setting to be
added and then click "Add". Then this Port Mapping setting will be added into the "Current
Port Mapping Table" below. If you find any typo before adding it and want to retype again,
just click <Reset> and the fields will be cleared.
Remove Port Mapping
If you want to remove a Port Mapping setting from the "Current Port Mapping Table",
select the Port Mapping setting that you want to remove in the table and then click
D<Delete Selected>. If you want to remove all Port Mapping settings from the table, click
<Delete All> button. Click <Reset> will clear your current selections.
Click <Apply> at the bottom of the screen to save the above configurations.
To Next Page
Loading...
