Endress+Hauser Ecograph RSG35 - Page 133

Ecograph T, RSG35 Appendix
Endress+Hauser 133
Modbus
Navigation Expert → Communication → Modbus Slave → Modbus
Direct access code: 480000-000
Description Specify the physical interface you wish to use.
Options Not used, RS485, Ethernet
Factory setting Not used
Unit address
Navigation Expert → Communication → Modbus Slave → Unit address
Direct access code: 480001-000
Description Enter the device address where it should be possible to reach this device in the bus.
Only visible if Modbus = RS485.
User entry 1 to 247
Factory setting 1
Port
Navigation Expert → Communication → Modbus Slave → Port
Direct access code: 480004-000
Description Port via which the Modbus protocol can be activated.
Only visible if Modbus = Ethernet.
User entry Number (max. 5 digits)
Factory setting 502
"Serial interface" submenu
Navigation Expert → Communication → Modbus Slave → Serial interface
Description Contains settings for the serial interface.
Only visible if Modbus = RS485.
Baud rate