Basic safety instructions Ecograph T, RSG35
8 Endress+Hauser
Internet Explorer
®
, Excel
TM
Registered trademarks of the Microsoft Corporation
Mozilla Firefox
®
Registered trademark of the Mozilla Foundation
Opera
®
Registered trademark of Opera Software ASA.
Google Chrome
TM
Registered trademark of Google INC.
2 Basic safety instructions
Reliable and safe operation of the device is guaranteed only if the user reads these
Operating Instructions and complies with the safety instructions they contain.
2.1 Requirements concerning the staff
The personnel for installation, commissioning, diagnostics and maintenance must fulfill
the following requirements:
‣
Trained, qualified specialists: must have a relevant qualification for this specific
function and task
‣
Are authorized by the plant owner/operator
‣
Are familiar with federal/national regulations
‣
Before beginning work, the specialist staff must have read and understood the
instructions in the Operating Instructions and supplementary documentation as well as
in the certificates (depending on the application)
‣
Following instructions and basic conditions
The operating personnel must fulfill the following requirements:
‣
Being instructed and authorized according to the requirements of the task by the
facility's owner-operator
‣
Following the instructions in these Operating Instructions
2.2 Designated use
This device is designed for the electronic acquisition, display, recording, analysis, remote
transmission and archiving of analog and digital input signals in non-hazardous areas.
• The manufacturer accepts no liability for damages resulting from incorrect use or use
other than that designated. It is not permitted to convert or modify the device in any
way.
• The device is designed for installation in a panel and must only be operated in an
installed state.
2.3 Workplace safety
For work on and with the device:
‣
Wear the required personal protective equipment according to federal/national
regulations.
2.4 Operational safety
Risk of injury.
‣
Operate the device in proper technical condition and fail-safe condition only.
‣
The operator is responsible for interference-free operation of the device.
To Next Page
Loading...
Need help?
General