Endress+Hauser Ecograph RSG35 - Application Submenu

Appendix Ecograph T, RSG35
134 Endress+Hauser
Navigation Expert → Communication → Modbus Slave → Serial interface → Baud rate
Direct access code: 150101-000
Description Transmission speed ("Baud rate") - must be the same as the settings for the PC software.
Only visible if Modbus = RS485.
Options 9600, 19200, 38400, 57600, 115200
Factory setting 19200
Parity
Navigation Expert → Communication → Modbus Slave → Serial interface → Parity
Direct access code: 150103-000
Description Parity
Only visible if Modbus = RS485.
Options None, Even, Odd
Factory setting None
Stop bits
Navigation Expert → Communication → Modbus Slave → Serial interface → Stop bits
Direct access code: 150104-000
Description Parity
Only visible if Modbus = RS485 and parity = none.
Options 1, 2
Factory setting 1
16.1.5 "Application" submenu
Configure various application-specific settings (e.g. group settings, limit values, etc.).
Submenu "Maths - Maths x"
Navigation Expert → Application → Maths → Maths x
Description Configuration of the mathematics channels.
x = place holder for selected mathematics channel.