Commissioning Ecograph T, RSG35
36 Endress+Hauser
9.5 Advanced settings (Expert menu)
You can access the main menu by pressing the Navigator during operation. Turn the
Navigator to navigate to the "Expert" menu. Press the Navigator to open the menu.
The Expert menu is protected by the code "0000". If an access code is set up under
"Setup -> Advanced setup -> System -> Security -> Protected by -> Access code",
this must be entered here.
The "Expert" menu contains all of the device settings:
Parameters Possible settings Description
Direct access 000000-000 Direct access to parameters (fast access)
System Basic settings that are needed to operate the device,
(e.g. date/ time, security, memory management,
messages, etc.)
Inputs Settings for analog and digital inputs
Outputs Settings only required if outputs (e.g. relays or
analog outputs) are to be used
Communication Settings required if the USB, RS232/RS485 or
Ethernet interface of the device is to be used (PC
operation, serial data export, modem operation, etc.)
The different interfaces (USB, RS232/RS485,
Ethernet) can be operated in parallel. However,
simultaneous use of the RS232 and RS485
interface is not possible.
Application Configure various application-specific settings (e.g.
group settings, limit values, etc.)
Diagnosis Device information and service functions for a swift
device check
A detailed overview of all the operating parameters is provided in the appendix at the
end of the Operating Instructions. → 78
9.6 Configuration management
You can save the setup data ("Configuration") to an SD card or a USB stick, to a PC
drive via the Web server, or store them in a database using the configuration
software. This allows additional devices to be configured very easily using the same
settings.
Save setup: The function used to save the setup files can be found in the main menu under
"Operation -> SD card (or USB stick) -> Save setup".
L
CAUTION
If the SD card or USB stick are removed directly:
Risk of data loss on SD card or USB stick.
‣
To remove the SD card or the USB stick, always select "Operation -> SD card (or USB
stick) -> Remove safely" in the main menu!
Procedure for saving a setup via the Web server:
1. Make the connection to the device with the Web server → 34
2. Click "Data management -> Save device settings" in the Web server function bar
3. Select the setup file
4. Transfer the file
5. Verify and accept
To Next Page
Loading...