Endress+Hauser Hart Proline Promag P 500 - Page 113

Proline Promag P 500 HART Commissioning
Endress+Hauser 113
Device type
→  113
Manufacturer ID
→  113
Burst command
→  113
Slot number
→  113
Timeout
→  114
Failure mode
→  114
Failure value
→  114
"Configuration" submenu
Navigation
"Expert" menu → Communication → HART input → Configuration
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry
Factory setting
Capture mode – Select capture mode via burst
or master communication.
• Off
• Burst network
• Master network
Off
Device ID The Master network option is
selected in the Capture mode
parameter.
Enter device ID of external
device.
6-digit value:
• Via local
operation: enter as
hexadecimal or
decimal number
• Via operating tool:
enter as decimal
number
0
Device type In the Capture mode
parameter, the Master
network option is selected.
Enter device type of external
device.
2-digit hexadecimal
number
0x00
Manufacturer ID The Master network option is
selected in the Capture mode
parameter.
Enter manufacture ID of
external device.
2-digit value:
• Via local
operation: enter as
hexadecimal or
decimal number
• Via operating tool:
enter as decimal
number
0
Burst command The Burst network option or
the Master network option
are selected in the Capture
mode parameter.
Select command to read in
external process variable.
• Command 1
• Command 3
• Command 9
• Command 33
Command 1
Slot number The Burst network option or
the Master network option is
selected in the Capture mode
parameter.
Define position of external
process variable in burst
command.
1 to 8 1