Endress+Hauser Hart Proline Promag P 500 - Page 120

Commissioning Proline Promag P 500 HART
120 Endress+Hauser
Navigation
"Setup" menu → Advanced setup → Totalizer 1 to n
‣
Totalizer 1 to n
Assign process variable
→  120
Unit totalizer 1 to n
→  120
Totalizer operation mode
→  120
Failure mode
→  120
Parameter overview with brief description
Parameter Prerequisite Description Selection Factory setting
Assign process variable – Select process variable for
totalizer.
• Off
• Volume flow
• Mass flow
• Corrected volume
flow
Volume flow
Unit totalizer 1 to n One of the following options is
selected in the Assign process
variable parameter
(→  120) of the Totalizer
1 to n submenu:
• Volume flow
• Mass flow
• Corrected volume flow
Select process variable totalizer
unit.
Unit choose list l
Totalizer operation mode – Select totalizer calculation
mode.
• Net flow total
• Forward flow total
• Reverse flow total
Net flow total
Failure mode – Define totalizer behavior in
alarm condition.
• Stop
• Actual value
• Last valid value
Stop