Endress+Hauser iTEMP TMT82 - Decimal Places 1; Value 2 Display

iTEMP TMT82 Operating menu and parameter description
Endress+Hauser 79
Navigation Setup → Advanced setup → Display → Value 1 display
Expert → System → Display → Value 1 display
Description Use this function to select one of the measured values to be shown on the local display.
The Format display parameter is used to specify how the measured values are
displayed →  78.
Options: • Process value
• Sensor 1
• Sensor 2
• Output current
• Percent of range
• Device temperature
Factory settings Process value
Decimal places 1
Navigation Setup → Advanced setup → Display → Decimal places 1
Expert → System → Display → Decimal places 1
Prerequisite A measured value is specified in the Value 1 display parameter →  78.
Description Use this function to select the number of decimal places displayed for the display value.
This setting does not affect the accuracy of the device for measuring or calculating the
value.
If Automatic is selected, the maximum possible number of decimal places is always
shown on the display.
Options: • x
• x.x
• x.xx
• x.xxx
• x.xxxx
• Automatic
Factory settings Automatic
Value 2 display
Navigation Setup → Advanced setup → Display → Value 2 display
Expert → System → Display → Value 2 display
Description Use this function to select one of the measured values to be shown on the local display.
The Format display parameter is used to specify how the measured values are
displayed .