Operating menu and parameter description iTEMP TMT82
66 Endress+Hauser
13.1 "Setup" menu
This menu contains all the parameters that are needed to configure the basic settings of
the device. The transmitter can be put into operation with this limited parameter set.
n = Stands for the number of sensor inputs (1 and 2)
Device tag
Navigation Setup → Device tag
Diagnostics → Device information → Device tag
Expert → Diagnostics → Device information → Device tag
Description Use this function to enter a unique name for the measuring point so it can be identified
quickly within the plant. The name is displayed in the header of the plug-in display.
→ 14, 25
User entry Max. 32 characters, such as letters, numbers or special characters (e.g. @, %, /)
Factory setting -none-
Unit
Navigation Setup → Unit
Expert → System → Unit
Description Use this function to select the engineering unit for all the measured values.
Options • °C
• °F
• K
• °R
• Ohm
• mV
Factory setting °C
Sensor type n
Navigation Setup → Sensor type n
Expert → Sensor → Sensor n → Sensor type n
To Next Page
Loading...
