Identification iTEMP TMT82
8 Endress+Hauser
3 Identification
3.1 Device designation
The following options are available for identification of the device:
• Nameplate specifications
• Enter the serial number from the nameplate in the W@M Device Viewer
(www.endress.com/deviceviewer): All data relating to the device and an overview of
the Technical Documentation supplied with the device are displayed.
3.1.1 Nameplate
The right device?
Compare and check the data on the nameplate of the device against the requirements of
the measuring point:
1
2 3
4
5
11-42V
012345678910
xx.yy.zz
TMT82- XXXXX/XX
iTEMP
Made in Germany 2016
D-87484 Nesselwang
Ser.no.:
FW:
Input:
12345678ABCDEFGH
12345678ABCDEFGH
Current consum.: 23,6 mA
Dev.Rev: x
Ext. ord. cd.:
XXXXXXXXXXXXX#
EH 08.001X
II3G Ex nA II T6/T5/T4 Ta= -40 ...+ 55/70/85°C
II3G Ex nL IIC T6/T5/T4 Ta= -40 ... +55/70/85°C
Install per XA00102R/09/a3/xx.xx
6
0044
7
A0014561
1 Nameplate of the head transmitter (example, Ex version)
1 Power supply, current consumption and extended order code
2 Serial number, device revision and firmware version
3 Data Matrix 2D code
4 2 lines for the TAG name
5 Approval in hazardous area with number of the relevant Ex documentation (XA...)
6 Approvals with symbols
7 Order code and manufacturer ID
To Next Page
Loading...
