Operating menu and parameter description iTEMP TMT82
60 Endress+Hauser
13 Operating menu and parameter description
The following tables list all the parameters in the "Setup", "Diagnostics" and "Expert"
operating menus. The page reference indicates where a description of the parameter
can be found in the manual.
Depending on the parameter configuration, not all submenus and parameters are
available in every device. Information on this can be found in the parameter
description under "Prerequisite". The parameter groups for the Expert setup contain all
the parameters of the "Setup" and "Diagnostics" operating menus, as well as other
parameters that are solely reserved for experts.
This symbol indicates how to navigate to the parameter using operating tools (e.g.
FieldCare).
Configuration in the SIL mode differs from the standard mode and is described in the
Functional Safety Manual.
For more information please refer to the Functional Safety Manual SD01172T/09.
Setup → Device tag → 66
Unit → 66
Sensor type 1 → 66
Connection type 1 → 67
2-wire compensation 1 → 67
Reference junction 1 → 67
RJ preset value 1 → 68
Sensor type 2 → 66
Connection type 2 → 67
2-wire compensation 2 → 67
Reference junction 2 → 67
RJ preset value 2 → 68
Assign current output (PV) → 68
Lower range value → 69
Meas. range end → 69
Setup → Extended Setup→ Enter access code → 70
Access status tooling → 71
Locking status → 71
Device temperature alarm → 72
Setup → Extended Setup→ Sensor → Sensor offset 1 → 72
Sensor offset 2 → 72
Corrosion detection → 72
Drift/difference mode → 73
Drift/difference alarm category → 73
Drift/difference alarm delay → 74
Drift/difference set point → 74
Sensor switch set point → 74
To Next Page
Loading...
