Endress+Hauser Levelflex FMP54 - Page 204

Operating menu Levelflex FMP51, FMP52, FMP54 FOUNDATION Fieldbus
204 Endress+Hauser
"Probe length correction" wizard
The Probe length correction wizard is only available when operating via the local
display. When operating via an operating tool, all parameters concerning the probe
length correction are located directly in the Probe settings submenu (→  202).
Navigation  Setup → Advanced setup → Probe settings → Prob.length corr
Confirm probe length 
Navigation  Setup → Advanced setup → Probe settings → Prob.length corr → Confirm length
Description →  203
Present probe length 
Navigation  Setup → Advanced setup → Probe settings → Prob.length corr → Pres. length
Description →  202