Endress+Hauser Levelflex FMP54 - Analog Input 1 to 5 Submenu

Operating menu Levelflex FMP51, FMP52, FMP54 FOUNDATION Fieldbus
232 Endress+Hauser
Thickness upper layer
Navigation  Diagnostics → Measured val. → Thickn.upp.layer
Prerequisite Operating mode (→  159) = Interface or Interface with capacitance
Description Displays the upper interface thickness (UP).
Additional information
UP
UP
A0013313
UP Thickness upper layer
The unit is defined by the Unit after linearization parameter →  192.
Terminal voltage 1
Navigation  Diagnostics → Measured val. → Terminal volt. 1
Description Dipslays terminal voltage at the current output.
17.4.5 "Analog input 1 to 5" submenu
There is an Analog inputs submenu for every AI block of the device. The AI block is used
to configure the measured value transmission to the bus.
Only the most basic properties of the AI block can be configured in this submenu. For
a detailed configuration of the AI blocks refer to the Expert menu.