EasyManua.ls Logo

Endress+Hauser Micropilot FMR60B - Mounting; Mounting Location

Endress+Hauser Micropilot FMR60B
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Micropilot FMR60B PROFINET with Ethernet-APL
20 Endress+Hauser
Gas phase Temperature Pressure
1 bar (14.5 psi) 10 bar (145 psi) 25 bar (362 psi)
+400 °C (+752 °F) –0.02 % +0.03 % +0.11 %
Water (saturated steam) +100 °C (+212 °F) +0.02 % - -
+180 °C (+356 °F) - +2.10 % -
+263 °C (+505 °F) - - +4.15 %
+310 °C (+590 °F) - - -
+364 °C (+687 °F) - - -
With a known, constant pressure, it is possible to compensate for this measured error with a
linearization, for example.
Mounting
Mounting location
A
1
2
3
A0016882
A Recommended distance from wall to nozzle outer edge ~ 1/6 of the vessel diameter. The device should never
be mounted closer than 15 cm (5.91 in) to the tank wall.
1 Use of a weather protection cover; protection from direct sunlight or rain
2 Installation in the center, interference can cause signal loss
3 Do not install above the filling curtain

Table of Contents

Other manuals for Endress+Hauser Micropilot FMR60B

Related product manuals