Micropilot FMR60B PROFINET with Ethernet-APL
Endress+Hauser 57
CE mark
The measuring system meets the legal requirements of the applicable EU directives. These are listed
in the corresponding EU Declaration of Conformity together with the standards applied.
The manufacturer confirms successful testing of the device by affixing to it the CE mark.
RoHS
The measuring system meets the substance restrictions of the Directive on the Restriction of the Use
of Certain Hazardous Substances 2011/65/EU (RoHS 2) and the Delegated Directive (EU) 2015/863
(RoHS 3).
RCM marking
The supplied product or measuring system meets the ACMA (Australian Communications and Media
Authority) requirements for network integrity, interoperability, performance characteristics as well
as health and safety regulations. Here, especially the regulatory arrangements for electromagnetic
compatibility are met. The products bear the RCM marking on the nameplate.
A0029561
Ex approvals
Additional safety instructions must be followed for use in hazardous areas. Please refer to the
separate "Safety Instructions" (XA) document included in the delivery. Reference to the applicable XA
can be found on the nameplate.
Explosion-protected smartphones and tablets
If used in hazardous areas, mobile end devices with an Ex approval must be used.
Pressure equipment with
allowable pressure ≤
200 bar (2 900 psi)
Pressure instruments with a flange and threaded boss that do not have a pressurized housing do not
fall within the scope of the Pressure Equipment Directive, irrespective of the maximum allowable
pressure.
Reasons:
According to Article 2, point 5 of EU Directive 2014/68/EU, pressure accessories are defined as
"devices with an operational function and having pressure-bearing housings".
If a pressure instrument does not have a pressure-bearing housing (no identifiable pressure chamber
of its own), there is no pressure accessory present within the meaning of the Directive.
Radio approval
Displays with Bluetooth LE have radio licenses according to CE and FCC. The relevant certification
information and labels are provided on display.
EN 302729 radio standard
Devices with following listed antennas are compliant with the radio standard EN 302729 for LPR
(Level Probing Radar):
• Encapsulated antenna, PVDF, 40 mm (1.5 in)
• Drip-off antenna 50 mm (2 in)
• Integrated antenna, PEEK, 20 mm (0.75 in)
• Integrated antenna, PEEK, 40 mm (1.5 in)
The devices are approved for unrestricted use inside and outside closed containers in countries of the
EU and the EFTA. As a prerequisite, the countries must have already implemented this standard.
The standard is already implemented in the following countries:
Belgium, Bulgaria, Germany, Denmark, Estonia, France, Greece, UK, Ireland, Iceland, Italy,
Liechtenstein, Lithuania, Latvia, Malta, The Netherlands, Norway, Austria, Poland, Portugal,
Romania, Sweden, Switzerland, Slovakia, Spain, Czech Republic and Cyprus.
Implementation is still underway in all of the countries not listed.
Please note the following for the operation of the devices outside of closed vessels:
• Installation must be carried out by properly trained, expert staff.
• The device antenna must be installed in a fixed location pointing vertically downwards.
• The installation site must be located at a distance of 4 km (2.49 mi) from the astronomy stations
listed or otherwise approval must be provided by the relevant authority. If a device is installed
within a radius of 4 to 40 km (2.49 to 24.86 mi) around one of the listed stations, it must not be
installed at a height of more than 15 m (49 ft) above the ground.
To Next Page
Loading...
