Endress+Hauser Mycom CLM 152 User Manual

45
Relay contact of non-Ex version in case of power failure:
1)
Active (N.O. contact is closed, N.C. contact is open)
2)
Passive (N.O. contact is open, N.C. contact is closed)
3)
Open.
KYCFeludoMnoisnapxEhtiwstnemngissAtcatnoC
noitceleS
,"RUMAN"
timil
/"RUMAN"
gnihctiwsRM
/ecnanetniaM
SRM/timil
timiLx1
naelcomehC
timiLx2
naelcomehC
/WG/RUMAN
PSU
tcatnoceruliaF
68/58.mret
eruliaF
)1
eruliaF
)1
eruliaF
)1
eruliaF
)1
eruliaF
)1
eruliaF
)1
1tcatnoC
88/78.mret
ecnanetniaM
deriuqer
)2
ecnanetniaM
deriuqer
)2
ecnanetniaM
deriuqer
)2
ecnanetniaM
deriuqer
)2
timiL
tcatnoc
)2
ecnanetniaM
deriuqer
)2
2tcatnoC
09/98.mret
noitcnuF
kcehc
)2
noitcnuF
kcehc
)2
timiL
1tcatnoc
)2
timiL
1tcatnoc
)2
timiL
2tcatnoc
noitcnuF
kcehc
)2
3tcatnoC
29/19.mret
timiL
1tcatnoc
)2
1SRM
)2
1SRM
)2
retaW
)3
retaW
)3
miL
ti
1tcatnoc
)2
4tcatnoC
49/39.mret
timiL
2tcatnoc
)2
2SRM
)2
2SRM
)2
renaelC
)3
renaelC
)3
PSU
)2
Note!
The “failure contact” is activated by system errors and defects (error codes 1 -
23) which would cause instrument failure.
Current outputs 1 and 2 output the defined error current (see chapter 7.2.1).
The failure contact is an obligatory part of all instrument configurations.
If configured, the “maintenance required” contact signals the instrument or
process faults which permit operation to continue but make it necessary to
check the measuring system.
Error codes 30 to 52 or 30 to 78 will cause maintenance required to be
signalled according to the configuration described in 7.1.4.
The “function check” contact is activated in the hold state and when the
instrument configuration is changed (e.g. during calibration).

Endress+Hauser Mycom CLM 152 Specifications

General

Brand	Endress+Hauser
Model	Mycom CLM 152
Category	Transmitter
Language	English