Endress+Hauser Proline Promass I 300

To Next Page

To Previous Page

Proline Promass I 300 PROFINET Diagnostics and troubleshooting

Endress+Hauser 213

Diagnostic information Remedy instructions

No. Short text

913 Medium unsuitable 1. Check process conditions

2. Check electronic modules or sensor

Measured variable status [from the factory]

Quality Good

Quality substatus Ok

Coding (hex) 0x80 to 0x83

Status signal S

Diagnostic behavior Warning

Influenced measured variables

• Oscillation amplitude 1

• Oscillation amplitude 2

• Application specific output

• Signal asymmetry

• Carrier mass flow

• Carrier pipe temperature

• Target corrected volume flow

• Carrier corrected volume flow

• Concentration

• Oscillation damping 1

• Oscillation damping 2

• Density

• Oil density

• Water density

• Dynamic viscosity

• Sensor electronic temperature (ISEM)

• GSV flow

• GSV flow alternative

• Kinematic viscosity

• Mass flow

• Oil mass flow

• Water mass flow

• Index inhomogeneous medium

• Index suspended bubbles

• HBSI

• NSV flow

• NSV flow alternative

• External pressure

• Exciter current 1

• Exciter current 2

• Oscillation frequency 1

• Oscillation frequency 2

• S&W volume flow

• Reference density

• Reference density alternative

• Corrected volume flow

• Oil corrected volume flow

• Water corrected volume flow

• Oscillation damping fluctuation 1

• Oscillation damping fluctuation 2

• Frequency fluctuation 1

• Frequency fluctuation 2

• Target mass flow

• Carrier volume flow

• Target volume flow

• Temp. compensated dynamic viscosity

• Temp. compensated kinematic viscosity

• Temperature

• Status

• Volume flow

• Oil volume flow

• Water volume flow

• Water cut

1) Diagnostic behavior can be changed. This causes the overall status of the measured variable to change.