Endress+Hauser Proline Prowirl 72 - Page 110

11 Operation via FOUNDATION Fieldbus Proline Prowirl 72 FOUNDATION Fieldbus
110 Endress + Hauser
Display - 
Language
AUTO - OOS Use this function to select the language for all texts and messages shown on
the local display.
Options:
English
Deutsch
Francais
Espanol
Italiano
Nederlands
Norsk
Svenska
Suomi
Portugues
Polski
Cesky
Factory setting
Depends on country (metric system units,Page 121, or US units,
Page 122)
Display -
Format
AUTO - OOS Use this function to define the maximum number of places after the decimal
point for the value displayed in the main line.
Options:
XXXXX. 
XXXX.X 
XXX.XX 
XX.XXX 
X.XXXX
Factory setting
XX.XXX
! Note!
• Note that this setting only affects the reading as it appears on the display,
it has no influence on the accuracy of the system's calculations.
• The places after the decimal point as computed by the measuring device
cannot always be displayed, depending on this setting and the engineering
unit. In these instances an arrow appears on the display between the
measured value and the engineering unit (e.g. 1.2 kg/h), indicating
that the measuring system is computing with more decimal places than
can be shown on the display.
Display -
Damping
AUTO - OOS Use this function to enter a time constant defining how the display reacts to
severely fluctuating flow variables, either very quickly (enter a low time
constant) or with damping (enter a high time constant).
User input:
0 to 100 s
Factory setting
5 s
! Note!
• The setting 0 seconds switches off damping.
• The function reaction time depends on the time specified in the "System
Param. - Flow Damping" function (Page 99).



Transducer Block "Display" (Endress+Hauser parameters) / base index 700
Parameter Write access for
operating mode
(MODE_BLK)
Description