Endress+Hauser Proline Prowirl 72 - Page 109

Proline Prowirl 72 FOUNDATION Fieldbus 11 Operation via FOUNDATION Fieldbus
Endress + Hauser 109
Line 2-
Assign
AUTO - OOS Use this function to define which display value is assigned to the additional
line (bottom line of the local display) for display during normal measuring
operation.
Options:
Off
Volume Flow
Volume Flow in %
Volume Flow Bargr. %
Mass Flow
Mass Flow in %
Mass Fl.Bargr.%
Corr. Volume Flow
Corr. Volflow in %
Corr. VolFl.Bar.%
Totalizer 1
Oper/Sys.Condit.
Tag Name
AI1 - OUT VALUE
AI2 - OUT VALUE
Factory setting:
Totalizer
Line 2-
100%-Value
AUTO - OOS
! Note!
The entry made only becomes effective if one of the following options was
selected in the "Add. Line - Assign" parameter:
Volume Flow in %
Volume Flow Bargr. %
Mass Flow in %
Mass Fl.Bargr.%
Corr. Volflow in %
Corr. VolFl.Bar.%
Use this function to specify the flow value to be shown on the display as the
100% value.
User input:
5-digit floating-point number
Factory setting
Depends on country (metric system units,Page 121, or US units,
Page 122)



















Transducer Block "Display" (Endress+Hauser parameters) / base index 700
Parameter Write access for
operating mode
(MODE_BLK)
Description