Endress+Hauser Proline t-mass 65 - Page 113

Proline t-mass 65 PROFIBUS DP/PA Technical data
Endress+Hauser 113
t-mass F sensor
Sensor body:
• DN 15 to 25 (DN ½" to DN 1"): stainless steel cast CF3M-A351
• DN 40 to 100 (DN 1 ½" to DN 4"): 1.4404 to EN10216-5 and 316/316L to A312
Flanges (process connections):
According to EN 1092-1 (DIN 2501/DIN 2512N) / ANSI B16.5 / JIS B2220
 stainless steel 1.4404 to EN 10222-5 and 316L/316 to A182
Transducer body:
• 1.4404 to EN10272 and 316L to A479
• Alloy C22 (2.4602) and UNS N06022 to B574
Transducer elements:
• 1.4404 to EN10217-7 and 316L to A249 or
• 1.4404 to EN 10216-5 and 316L to A213
• Alloy C22 (2.4602) and UNS N06022 to B626
Bushing:
PEEK GF30, PVDF
O-ring seals:
EPDM, Kalrez 6375, Viton FKM
t-mass I sensor
Insertion tube:
Sensor length 235 (9"), 335 (13"), 435 (17"), 608 (24")
1.4404 to EN 10216-5 and 316/316L to A312
Transducer body:
• 1.4404 to EN10272 and 316L to A479
• Alloy C22 (2.4602) and UNS N06022 to B574
Transducer elements:
• 1.4404 to EN10217-7 and 316L to A249 or
• 1.4404 to EN 10216-5 and 316L to A213
• Alloy C22 (2.4602) and UNS N06022 to B626
Protection gaurd:
1.4404 to EN 10088-1 and EN 10088-2 + 2B and 316L to A666
Compression fitting:
1.4404 to EN 10272 and 316/316L to A479
Ferrules:
PEEK 450G, PVDF
Bonded seals:
EPDM, Kalrez 6375, Nitrile and 316/316L (outer ring)
Hot tap
Lower tube section:
1.4404 to EN 10272 and 316/316L to A479
Upper tube section:
1.4404 to EN 10216-5 and 316/316L to A312
Ball valve:
CF3M and CF8M
Seal:
PTFE