Endress+Hauser Proline t-mass 65 - Operation; Quick Operation Guide

Operation Proline t-mass 65 PROFIBUS DP/PA
36 Endress+Hauser
5Operation
5.1 Quick operation guide
The user has a number of options for configuring and commissioning the device:
1. Local display (option)  ä 37
The local display enables you to read all important variables directly at the measuring point,
configure device-specific parameters in the field and perform commissioning.
2. Configuration programs  ä 41
The configuration of profile and device-specific parameters is primarily done via the PROFIBUS
interface. You can obtain special configuration and operating programs from various
manufacturers for these purposes.
3. Jumpers/miniature switches for hardware settings
–PROFIBUS DP  ä 43
–PROFIBUS PA  ä 46
You can make the following hardware settings using a jumper or miniature switches on the
I/O board:
• Address mode configuration (select software or hardware addressing)
• Device bus address configuration (for hardware addressing)
• Hardware write protection enabling/disabling
a0001318
Fig. 26: Methods of operating PROFIBUS
1 Local display for device operation in the field (option)
2A Configuration/operating programs (e.g. FieldCare) for operation via PROFIBUS DP/PA
2B Configuration/operating program for operation via service interface FXA193 (e.g. FieldCare)
3 Jumper/miniature switches for hardware settings (write protection, device address, address mode)
2A
3
1
Esc
E
- +
Esc
E
+
-
XXX.XXX.XX
Esc
E
- +
FXA193
2B