Endress+Hauser Proline t-mass 65 - Quick Setup: Gas Configuration

Commissioning Proline t-mass 65 PROFIBUS DP/PA
52 Endress+Hauser
6.3.3 "Gas" Quick Setup menu
The device can be setup with 1 or 2 individual gas groups in memory. This means that up to 2
different gas flow streams (e.g. nitrogen and argon) can be measured in a single pipe with one
flowmeter.
In the case of 2 gas groups being used, a digital input can be assigned to switch between the gas
groups or, alternatively, the switch can be done manually via a function in the device software.
A0009907-en
Programming a gas group
The device allows flexible change of the gas group parameters, independent of the original factory
setup and calibration
A gas group can be programmed as:
– one single gas or
– one gas mixture (of up to 8 components)
A single gas can be:
– selected from a list of standard gases or
– setup for other suitable types of gases, such as Ozone, using manual correction factors and the
option called SPECIAL GAS. This requires application evaluation at the factory - consult your
Endress+Hauser representative prior to using this function.
+
+
E
Esc
E
+
-
XXX.XXX.XX
HOME-POSITION
+
E
QUICK SETUP
QS
GAS
DESCRIPTION 1
CORRECTION
FACTOR 1
REFERENCE
DENSITY1
GAS GROUP 1
NUMBER OF
GASES
GAS TYPE
2…8
MOLE % GAS
2…8
CHECK
VALUES
CANCEL
YES
NO
Selection
SAVE CHANGES?
Selection of Gas Group
Configure Another Group?
DESCRIPTION 2
MOLE % GAS 1
MOLE % GAS 1
QUIT
GAS GROUP 2
NUMBER OF
GASES
GAS TYPE 1
GAS TYPE 1
GAS TYPE
2…8
MOLE % GAS
2…8
CHECK
VALUES
CORRECTION
FACTOR 2
REFERENCE
DENSITY2
YESDISCARD
SELECT
GROUP
ANALYZER
INPUT
ANALYZER
INPUT