Proline t-mass 65 PROFIBUS DP/PA Trouble-shooting
Endress+Hauser 93
035 S: SENS HW-ROM/RAM
$: # 035
0x10
0x11
0x12
BAD Sensor Failure O.K.
Low
High
Sensor:
Defective ROM/
RAM
Cause:
Sensor: Defective ROM/RAM
Remedy:
Replace the remote amplifier board.
036 S: SENS SW-ROM/RAM
$: # 036
0x10
0x11
0x12
BAD Sensor Failure O.K.
Low
High
Sensor:
Defective ROM/
RAM
Cause:
Sensor: Defective ROM/RAM
Remedy:
Replace the remote amplifier board.
042 S: TRANSM. SW-DAT
$: # 042
0x0F BAD Device Failure Constant T-DAT data
inconsistent
Cause:
Error accessing the calibration values stored in the
HistoROM/T-DAT.
Remedy:
1. Check whether the HistoROM/T-DAT is
correctly plugged into the amplifier board.
ä 100, ä 102
2. Replace the HistoROM/T-DAT if it is
defective. ä 99,
Before replacing the DAT, check that the new,
replacement DAT is compatible with the
measuring electronics. Check the:
– Spare parts set number
– Hardware revision code
3. Replace measuring electronics boards if
necessary.
051 AC COMPATIB.
$: # 051
0x0F BAD Device Failure Constant Compatibility Amp.
I/O module
Cause:
The I/O board and the amplifier board are not
compatible.
Remedy:
Use only compatible modules and boards.
Check the compatibility of the modules used.
Check the:
– Spare parts set number
– Hardware revision code
070 S: SENSOR DEFECT
$: # 070
0x13 BAD Sensor Failure Constant Sensor failure Cause:
Flow sensors are likely to be defect, measurement
is no longer possible.
Remedy:
Contact your Endress+Hauser representative.
No. # 1xx Software error
111 S: CHECKSUM TOTAL
$: # 111
0x0F BAD Device Failure Constant Totalizer checksum
error
Cause:
Totalizer checksum error
Remedy:
1. Restart the measuring device
2. Replace the amplifier board if necessary.
No. Device status message
(local display)
PROFIBUS measured value status
Extended
diagnostic
message in the
PROFIBUS
master
Remedy / spare parts
Spare parts ä 99
Quality code (HEX)
Measured variable status
Quality status
Quality substatus
Limits
To Next Page
Loading...
