Endress+Hauser Smartec S CLD132 - Post Mounting Kit; Software Upgrade; Calibration Solutions; Optoscope

Accessories Smartec S CLD132
60 Endress+Hauser
8.4 Post mounting kit
❑ Mounting kit for installation of Smartec S CLD132 on horizontal or vertical pipes and posts
(max. Ø 60 mm / 2.36"), material stainless steel 1.4301;
order no.: 50062121
C07-CLD132xx-00-06-06-001.eps
Fig. 40: Mounting kit for installing CLD132 separate version on posts or pipes
8.5 Software upgrade
❑ Software upgrade
Remote parameter set switching (measuring range switching, MRS) and determination of
temperature coefficient;
order no.: 51501643
Serial number of instrument must be specified with order.
8.6 Calibration solutions
Precision solutions, traceable to SRM (standard reference material) by NIST, for qualified calibration
of conductivity measurement systems according to ISO 9000, with temperature table
❑ CLY11-B
149.6 µS/cm (reference temperature 25 °C / 77 °F), 500 ml / 0.13 US.gal.
Order no. 50081903
❑ CLY11-C
1.406 mS/cm (reference temperature 25 °C / 77 °F), 500 ml / 0.13 US.gal.
Order no. 50081904
❑ CLY11-D
12.64 mS/cm (reference temperature 25 °C/ 77 °F), 500 ml / 0.13 US.gal.
Order no. 50081905
❑ CLY11-E
107.0 mS/cm (reference temperature 25 °C / 77 °F), 500 ml / 0.13 US.gal
Order no. 50081906
8.7 Optoscope
❑ Optoscope
Interface between transmitter and PC / laptop for service purposes.
The Windows software "Scopeware" required for the PC or laptop is supplied with the Optoscope.
The Optoscope is supplied in a sturdy plastic case with all the accessories required.
Order no. 51500650