Smartec S CLD132 Installation
Endress+Hauser 9
3 Installation
3.1 Quick installation guide
The following procedure should be followed for a complete measuring point installation:
Compact version:
• Perform an Airset. Install the compact version at the measuring point (see chapter "Mounting
CLD132 compact version").
• Connect the compact version as described in the chapter "Electrical connection".
• Start up the compact version as described in the chapter "Commissioning".
Separate version:
• Mount the transmitter (see chapter "Mounting CLD132 separate version").
• If you have not yet installed the sensor at the measuring point, perform an Airset and install the
sensor (see the Technical Information of the sensor).
• Connect the sensor to the Smartec S CLD132 as described in the chapter "Electrical connection".
• Connect the transmitter as described in the chapter "Electrical connection".
• Start up the Smartec S CLD132 as described in the chapter "Commissioning".
3.1.1 Measuring system
The complete measuring system comprises:
• the Smartec S CLD132 transmitter
• the conductivity sensor Indumax H CLS52 with an integrated temperature sensor and a fixed
cable
or
• the compact version with an integrated conductivity sensor
Optional for the separate version: CLK5 extension cable, VBM junction box, mounting kit for pipe
installation (see chapter "Accessories")
C07-CLD132xx-14-06-00-xx-001.eps
Fig. 2: Complete measuring systems Smartec S CLD132 as a separate transmitter and compact version with
integrated conductivity sensor
A CLS52 conductivity sensor
B Smartec S CLD132
C Smartec S CLD132 as compact version with integrated conductivity sensor
ENDRESS+HAUSER
SMARTEC S
ALARM
CAL
E
+
–
A
B
C
To Next Page
Loading...
