Smartec S CLD134 Installation
Endress+Hauser 11
3 Installation
3.1 Quick installation guide
The following procedure should be followed for a complete measuring point installation:
Compact version:
• Perform an air set. Install the compact version at the measuring point (see chapter "Mounting
CLD134 compact version").
• Connect the compact version as described in the chapter "Electrical connection".
• Start up the compact version as described in the chapter "Commissioning".
Separate version:
• Mount the transmitter (see chapter "Mounting CLD134 separate version").
• If you have not yet installed the sensor at the measuring point, perform an Airset and install the
sensor (see the Technical Information of the sensor).
• Connect the sensor to the Smartec S CLD134 as described in the chapter "Electrical connection".
• Connect the transmitter as described in the chapter "Electrical connection".
• Start up the Smartec S CLD134 as described in the chapter "Commissioning".
3.1.1 Measuring system
A complete measuring system comprises:
• the Smartec S CLD134 transmitter (separate version)
• the CLS54 conductivity sensor with integrated temperature sensor and fixed cable
or
• the CLD134 compact version with integrated CLS54 conductivity sensor
Optional for the separate version: CLK5 extension cable, VBM junction box, mounting kit for pipe
mounting
a0005438
Fig. 2: Complete measuring systems Smartec S CLD134 as separate transmitter and compact version
A CLS54 conductivity sensor
B Smartec S CLD134 transmitter
C Smartec S CLD134 compact version with integrated CLS54
ENDRESS+HAUSER
SMARTECS
ENDRESS+HAUSER
SMARTEC
S
ALARMALARM
CAL
E
+
–
A
B
C
To Next Page
Loading...
