Engcon EC02 - Table of Contents

Table of Contents
Table of Contents
1. Introduction
1.1. General............................................................................................................ 6
1.2. Scrapping and recycling..................................................................................6
1.3. Transport and storage..................................................................................... 6
1.3.1. Temperature during operation and storage..............................................7
1.4. Warranty.......................................................................................................... 7
1.5. Technical support and spare parts.................................................................. 7
1.6. Product approval............................................................................................. 8
1.6.1. EC Declaration of Conformity.................................................................. 8
1.6.2. Type certification for lifting hook.............................................................. 9
2. Safety
2.1. General............................................................................................................ 10
3. Design and function
3.1. General............................................................................................................ 11
3.2. Q-Safe............................................................................................................. 11
3.2.1. Overview.................................................................................................. 12
3.3. HS and SW quick coupler with sensor............................................................13
3.3.1. Overview.................................................................................................. 14
3.4. EC-Oil.............................................................................................................. 15
3.5. ePS/C2C..........................................................................................................16
3.5.1. Overview.................................................................................................. 16
4. Installation
4.1. Oil.................................................................................................................... 18
4.2. Identification.....................................................................................................18
4.3. Mechanical.......................................................................................................18
4.3.1. Attaching the tiltrotator.............................................................................19
4.4. Electrical and hydraulics..................................................................................21
4.4.1. Q-Safe......................................................................................................21
4.5. On completion................................................................................................. 22
5. Operation
5.1. Before and during use.....................................................................................23
5.2. Lifting points.................................................................................................... 24
5.3. Integrated grabber...........................................................................................24
5.4. Hydraulic hammers..........................................................................................25
5.5. Augers............................................................................................................. 25
5.6. Pallet forks.......................................................................................................25
5.7. Crane boom.....................................................................................................26
5.8. Maneuvering.................................................................................................... 26
5.8.1. DC2 control system (for machines with double-acting hydraulic circuit)... 26
5.8.2. Control system 10 (for machines with proportional control hydraulic
circuits).................................................................................................................
26
3