7. Product Description CC300 Operator Panel – User Guide
7.5.2. Closing the CC300 Operator Panel
Closing the CC300 operator panel will be performed in reverse order:
1. Carefully fold the aluminum rear cover back onto the front plate, but leave the rear cover open a few
inches (see Fig. 26).
It is recommended that the rear cover is held by a second person while the auxiliary switch block is
inserted into its mounting!
2. Press the auxiliary switch block of the emergency stop switch (see Fig. 28, Pos.13) into its mounting so
that it clicks into place (see Fig. 28, Pos.2 and Fig. 27).
3. Carefully close the housing completely. Make sure that no cables are jammed and that the surrounding
seal is in correct position and will not be damaged (see Fig. 28, Pos. 5).
4. Fix the rear cover to the front plate with the 10x screws (M5 x 10) and bonded seals removed in
chapter 7.5.1 “Opening the CC300 Operator Panel”, step 2 (see Fig. 17, Pos. 1).
Do not exceed the maximum torque of x Nm when fastening the cabinet screws!
(Value not yet defined!)
34 Preliminary Version 0.2
To Next Page
Loading...