4. General Safety Instructions for IT Equipment CC300 Operator Panel – User Guide
4. General Safety Instructions for IT Equipment
Please read this section carefully and observe the instructions for your own safety and correct use of the
device.
Observe the warnings and instructions on the device and in the manual.
The CC300 Operator Panel has been built and tested by Kontron Europe in accordance to
IEC/EN/UL/CSA 60950-1 (EN60950/VDE0805) and left the company in a perfectly safe condition.
In order to maintain this condition and ensure safe operation, the user must observe the instructions and
warnings contained in this manual.
This product shall be supplied by 60950-1 LPS or NEC Class 2 power supply.
The device must be used in accordance with the instructions for use.
The electrical installations in the room must correspond to the requirements of the local (country-
specific) regulations.
For DC power connection:
The DC power source should be able to be switched off and on via an isolating switch.
The unit is only completely disconnected from the DC main power source, when the DC power cord is
disconnected either from the power source or the unit. Therefore, the DC power cord and its
connectors must always remain easily accessible.
Do not place the device in direct sunlight, near heat sources or in a damp place. Make sure the device
has adequate ventilation.
Only devices and components which fulfill the requirements of an SELV circuit (safety extra low voltage)
in accordance with EN60950 may be connected to the interfaces of the system.
The device is designed to be used in vertical (diagonal) position.
The device generates heat during operation. Make sure it is adequately ventilated. Do not cover the
cooling fins on the rear side of the device.
Maintenance or repair on the open device may only be carried out by qualified personnel authorized by
Kontron Europe GmbH which is aware of with the associated dangers.
The device may only be opened in accordance with the description in this user guide for replacing the
Lithium battery. The device must be switched off and disconnected from the power source.
Only approved original accessories (optional parts) approved by Kontron Europe GmbH may be used.
The DC-input must fulfill SELV requirements of EN60950-1 standard.
The chassis of the CC300 Operator Panel must be protective earthed by establishing a large-area
contact between the grounding cable and an appropriate grounding connection point.
Preliminary Version 0.2 9
To Next Page
Loading...