EnGenius DuraFon - Base Features; Base Station Connections and Controls

~22~
Base Features
Basic Base Station Features
1.
Audio-In Jack (3.5mm)
Connect to an external device for music on hold.
2.
FXO Jack (L1)
Standard RJ-11 connector to plug in the telephone line.
3.
Ethernet Jack
Standard RJ-45 connector to plug in the Ethernet (LAN) line.
4.
Console Jack
Jack for console (Type-B USB connector).
5.
GND
Connecting the ground cable.
6.
REG button for Registration and Page
a.
Press and hold this REG button until the “INTERCOM” LED flashes status to
enter registration mode.
b.
To search for a misplaced handset; press “REG” button, all registered
handsets will beep for 30-seconds. Press “REG” again or any key on the
handset to stop.
7.
RESET Button
a.
Restores base station to factory settings.
b.
Reset button is intended to prevent accidental system reset.
c.
All handsets (including administrator) and additional base(s) need to be re-
registered after a base station reset. The web configuration is also to reset
to factory settings.
8.
DC In: to plug in the 12V DC power adapter.