EnGenius DuraFon - Call Manager; Managing Incoming and Outgoing Calls

~47~
Incoming
1.
Press MENU (Right) soft key followed by 4 to enter
the Call Settings mode.
Press 3 to select Call Manager, then enter handset’s
password (4-digits).
Call Settings:
3.Call Manager
SELECT BACK
a.
Press 1 to enable receiving PA On/Off.
Re: Default setting is “ON.”
Call Manager
2.Incoming
SELECT BACK
b.
Press 2 to enable receiving Line On/Off which includes
FXO line only.
Re: Default setting is “ON.”
c.
Press 3 to enable receiving Intercom On/Off.
Re: Default setting is “ON.”
(1) By default, all incoming calls will ring all handsets.
When entering this menu, you must enter handset password first (4-digits).
Re: The default handset password is “0000.”
Outgoing
1.
Press MENU (Right) soft key followed by 4 to enter the
Call Settings mode.
Press 3 to select Call Manager followed by entering
handset’s password (4-digits).
The handset is able to make outgoing calls via the SIP
line or PSTN line.
Call Settings:
3.Call Manager
SELECT BACK
Re: Default setting is “Auto.”
Call Manager
3.Outgoing
SELECT BACK
a.
Press 1 to “Auto.” The hanset is able to make outgoing
calls via an available line and SIP line automatically.