EnGenius DuraFon - Call Management Features; Hold, Mute, and Do Not Disturb Functions

~34~
Placing a Call On Hold
1.
When a call is in progress, it can be put on hold by pressing
OPTION (Right
) soft
key and the ＊ key.
You have a
call on hold
UNHOLD OPTION
2.
To return to the conversation, press UNHOLD (Left) soft
key.
Notes:
1. Handset LCD displays when a call is on hold. An alert tone (a beep)
every 30-seconds will remind the handset that a call is on hold.
2. If the operation (e.g., call transfer) fails after putting a call on-hold,
the held call may be dropped.
Mute
1.
After a link is established, you can press MUTE (Left) soft
key to mute the handset microphone.
00:00:15
MUTE
11
UNMUTE OPTION
L
1
2.
When mute is active, the other end will not hear your
voice, but can still speak to you.
3.
To leave the mute state, press UNMUTE (Left) soft key. Mute is effective only
for the current call.
Do Not Disturb (Silent Ring)
1.
Enter the key sequence MENU-3-1, then select “Off.” Press
SELECT (Left) soft key to confirm your choice. This will turn
off the ringer until it is turned on again from the menu.
Joe
033289289
SILENT
11
L
1
2.
For temporary silencing the ringer when an incoming call
arrives, press SILENT (Left) soft key.