EnGenius DuraFon - Advanced Operations; Handset Registration and De-registration

~36~
Advanced Operations
Handset Registration
1.
If your handset(s) is purchased as part of a system, it has been pre-registered
with the base station at the factory.
2.
If the Handset ID is “00,” this means it is a new handset or the ID has been
erased. You will need to register the handset with the base station.
3.
Registration:
a.
Press MENU-7 to enter the registration mode.
Main Menu
7.Registration
SELECT BACK
b.
Press and hold the base’s REG button for 3-seconds
until the INTERCOM LED lights up and flashes. The base
station will emit a prompt sound to remind you the
base station is in the registration mode.
c.
Press handset key 1 , this completes the registration
process. The base station will assign a handset ID
between 10 and 19 automatically. The assigned ID will
be displayed on the handset LCD, indicating successful
registration.
Registration
1.Register
SELECT BACK
d.
Repeat above steps for all additional handsets.
4.
De-registration:
a.
You can de-register the handset you’re using from the
base station. De-registration will reset the Handset ID
to 00, erase the system security code, and free up the
handset ID for future registration.
Main Menu
7.Registration
SELECT BACK
b.
After de-registration, the handset will not be able to
use the base station to make or receive phone calls, nor
can it intercom other handsets.
c.
Press MENU-7 to enter the registration mode.
Registration
2.Deregister
SELECT BACK
d.
Press and hold the base’s PAGE button for 3-seconds
until the In Use INTERCOM LED lights up and flashes,
also the base station will emit a prompt sound to
remind you the base station is in the de-registration
mode.
e.
Press the handset number key 2 , this completes the