Handset and Charger Installation
Plug the transformer end of the Charger AC/DC adapter into a standard AC
electric power outlet, plug the other end into the “DC In” jack on the back of
the Charger.
Install the battery pack onto the handset.
Install the handset antenna.
Place the handset onto the charger slot.
Fully charge the battery for three hours before use.
The phone system is now ready to perform basic functions such as making and
receiving phone calls and intercom calls. No base station or handset
programming is needed for basic operations.
Note:
1. Handset(s) packaged along with a Base Station are pre-registered at
the factory. If you have a new handset, you will need to register the
handset with the base station in order to be recognized as a member
handset by the base(s) and by other handsets. See Handset
Registration.
2. Fully charge battery packs before the first usage.
To Next Page
Loading...
