EnGenius DuraFon - Programmable Feature Call; Setting Up Programmable Feature Calls

~43~
ii. Start to receive the phone book, the LCD shows, “Get phone book from
Ext. # : xx.”
iii. A beep is emitted when receiving each phone book.
iv. When the phone book is being received, a 2-digit countdown shows on
the LCD to indicate the phone book numbers that are pending.
Re:
Since the phone book transfers through the wireless interface, it may
partially miss transmission if there is any interference.
11.
To transfer phone book via web:
You can edit/store 50-phone book entries via the web interface. The base can be
used as the sending party.
a.
Place the receiving handsets to Receiving mode, by pressing OPTION (Right)
soft key follow by 5 , 2 to enter Receiving mode. The LCD shows “Ready.”
b.
Press “Transfer” button on the web interface of the base to send up to 50-
entries of the phone book.
Re:
The handset will not update any phone book when it stores up to a
maximum of 50-entries.
Programmable Feature Call
1.
If DuraFon-SIP base station is installed behind a PBX system, it is feasible to pre-
program some call features along with the PBX’s feature code into the system.
2.
Up to 10 most frequently used feature call codes can be pre-programmed.
3.
Name and enter feature call codes:
Call Settings
4.Feature Call
SELECT BACK
a.
Press MENU (Right) soft key while the handset is in the
standby mode.
b.
Press 4 , followed by 4 to enter the “Feature Call”
menu.
c.
Press ADD (Left) soft key to add a new feature call
entry.
Empty
ADD
d.
Key in the name of the feature call, like editing a phone
book entry, i.e. “PBX Transfer.”
Press SAVE (Left) soft key to confirm.