To perform the test with heart-
rate measurement, first connect
the chest strap. The EN-Motion
will automatically detect
whether a heart-rate meter is
connected and whether a heart-
rate signal has been detected.
To perform the test without
heart-rate measurement, press
OK.
The Cooper test is performed
using Autospeed.
If the Autospeed function is set
to ‘secured’ in the default
settings, the access code must
first be entered before the
Autospeed function becomes
active (see § 10.6 and § 10.7).
If it is not secured, the
Autospeed function will be
activated immediately.
A screen will then appear stating that the test
will be performed in Autospeed mode.
The advantage of this is that the patient/user
is able to concentrate fully on running, and
the band speed will automatically adjust to
the pace of the user.
It is therefore not necessary to manually
increase or decrease the speed during the
test.
Press OK to START the test.
Comment: this test can also be performed without Autospeed. To do so, you must set the test speed
manually using the central rotary knob. Do this before pressing OK.
During the test, the most important
parameters will be displayed:
• time (remaining until the goal is reached)
• distance covered
• current heart rate (if a heart-rate belt is
worn)
• speed
To Next Page
Loading...
Need help?
General