Enttec S-PLAY - Triggers; Osc; Rs232

S-Play User Manual
Part No.: 51301
8 October 2020
(v23)
Document ID: 4686708 Page|43
Triggers
Use triggers to take control of the timeline of the playlist. When using a trigger, the timeline
will pause until the selected trigger is active.
Triggers can be used to start a playlist or at any point within the timeline.
When a playlist is waiting for a trigger, it will play by either activating the trigger or by pressing
play. This way there is full control of the playback even when the triggers are not available.
OSC
The S-Play can receive OSC through two key methods:
1). Triggers that can be created to start and resume
playlists.
2). Integration with the S-Plays OSC API to enable
control of:

Master intensity

Play, pause and stop all playlists

Play, pause and stop individual playlists

Per-playlist intensity control
Within the S-Plays Settings page, the global OSC receive port can be set, in addition to an
‘Export Playlists’ button that exports the ID’s of each playlist for use within the OSC API.
Visit www.enttec.com to download the OSC API, or follow this link.
RS232
RS232 Communication settings:

Bad Rate: 9600

Data: 8bits

Parity: none

Stop: 1bit

Flow Control: None
N.B. Command text is limited to 32 Characters only.