Enttec S-PLAY - Safety and Package Contents

S-Play User Manual
Part No.: 51301
8 October 2020
(v23)
Document ID: 4686708 Page|5
Safety

This unit is intended for indoor use only.

Do not expose this device to rain or moisture, doing this will void the warranty.

Make all the connections before you plug in the mains power

Do not remove the cover, there are no user-serviceable components inside.

Never plug this unit into a dimmer pack

Ensure proper earth connections

Always be sure to mount this unit in an area that will allow proper ventilation. Allow
about 6" (20 cm) between this device and a wall.

Power-supply cords should be routed so that they are not likely to be walked on or
pinched by items placed upon or against them, pay particular attention to the point
they enter and exit the unit.
Package Contents
When you open the packaging, you should find these items in the box:

S-Play (70092)

2m cat5 cable (79102)

1RU mount kit (79105)

1 X 12V PSU adaptor with international plugs

ReadMe Card