Enviro C60I - Page 12

12
Turn o the Appliance
Press the ON/OFF Key on the Transmitter. The Transmitter LCD display
will only show the room temperature and Icon (see Figure 9). A single
“beep” from the IFC conrms reception of the command and both the
pilot light (if the unit is not set to continuous pilot) and main burner will
turn o.
Room Thermostat (Transmitter Operation)
The Remote Control can operate as a room thermostat. The thermostat
can be set to a desired temperature to control the comfort level in a
room. To activate this function, press the Thermostat Key (see Figure
4). The LCD display on the Transmitter will change to show that the
room thermostat is “ON” and the set temperature is now displayed (see
Figure 9). To adjust the set temperature, press the Up or Down Arrow
Keys until the desired set temperature is displayed on the LCD screen of
the Transmitter.
Smart Thermostat (Transmitter Operation)
The Smart Thermostat function adjusts the ame height
in accordance to the dierence between the set point
temperature and the actual room temperatures. As the room
temperature gets closer to the set point the Smart Function
will modulate the ame down. To activate this function,
press the Thermostat Key (Figure 4) until the word “SMART”
appears to the right of the temperature bulb graphic (Figure
10). To adjust the set temperature, press the Up or Down
Arrow Keys until the desired set temperature is displayed on
the LCD screen of the Transmitter.
Room Temperature
Set Temperature
Thermostat ON
Figure 9: Remote Control Displays
Set Temperature.
Remote Flame Control
The Proame 2 remote control system has six (6) ame levels.
With the system on, and the ame level at the maximum
in the appliance, pressing the Down Arrow Key once will
reduce the ame height by one step until the ame is turned
o. The Up Arrow Key will increase the ame height each
time it is pressed. If the Up Arrow Key is pressed while the
system is on but the ame is o, the ame will come on in
the high position. A single “beep” will conrm reception of the
command.
Figure 10: Remote Control’s Smart Flame Function.
Figure 11: Remote Control’s Flame Levels.
Flame Off
Flame Level 1
Flame Level 5
Maximum Flame Level
Operating Instructions
Fan Control
The C60I has a dual convection fan kit that can be controlled
with the Transmitter. The fan speed can be adjusted thorugh
six (6) speeds. To control the fan press the Mode key to
index to the fan control icon. Use the UP/DOWN arrow keys
to turn on, o, or adjust the fan speed. A single beep from
the IFC will conrm the command has been received
Figure 12: Fan Control