Enviro C60I - Approved Venting Parts

33
Initial Installation
QUALIFIED INSTALLERS ONLY
Table 5: Approved Vent Manufacturers
Manufacturer Trade Name Nominal Sizes
ICC EXCELDirect 5” - 8”
M&G Dura-Vent Direct Vent Pro 5” - 8”
Selkirk DIRECT-TEMP 5” - 8”
Selkirk AMP DV 5” - 8”
The C60I replace has been tested and certied for use with M&G DuraVent DirectVent Pro, ICC EXCEL
Direct, Selkirk DIRECT-TEMP, and Selkirk AMP DV venting systems. Refer to the table below for part
numbers of commonly used parts for both venting systems. For more venting parts please visit the
respective manufacturers’ website.
WARNING: Do not mix parts from dierent vent manufacturers’ systems.
EXCEPTION TO WARNING: This product has been evaluated by Intertek for using a DirectVent Pro
starting collar in conjunction with EXCELDirect venting systems. Use of this system with the DirectVent Pro
starting collar is deemed acceptable and does not aect the Intertek listing of the appliance.
appRoVeD Venting paRts:
Table 6: Vent part numbers (Must state if galvanized or black wanted, PART NUMBERS)
Direct Vent Pro EXCELDirect DIRECT-TEMP AMP DV Description
58DVA-06 5DL6 5DT-06 6” pipe length
5D7 7” pipe length
58DVA-09 5DL9 5DT-09 9” pipe length
58DVA-12 5DL1 5DT-12 5D2 12” pipe length
58DVA-18 5DT-18 18” pipe length
58DVA-24 5DL2 5DT-24 24” pipe length
58DVA-36 5DL3 5DT-36 5D3 36” pipe length
58DVA-48 5DL4 5DT-48 5D4 48” pipe length
58DVA-60 60” pipe length
58DVA-E30 30° elbow, black
58DVA-E45 5DE45 5DT-EL45 5D45L 45° elbow, black
58DVA-E90 5DE90 5DT-EL90 5D90L 90° elbow, black
58DVA-VSS, DVA-BVS VSS 5DT-VS, VSK 5DHVS, DVSK Vinyl siding stando/sheild
58DVA-WT, 58DVA-WTU 5WT 5DT-WT 5DWT Wall thimble
58DVA-SC SQSC, SC 5DT-SC 5DSC Storm collar
58DVA-WFS 5DT-FS Wall Fire stop
58DVA-FS
5CS 5DT-FS 5DFSP Ceiling Fire stop
58DVA-IS
5AS 5DT-AIS 5DAIS12, AIS36 Attic Insulation Shield
58DVA-WS 5WS 5DT-WS/B 5DWS Wall strap/support/band
58DVA-VCH 5SVT 5DT-VT 5DVC High wind vertical termination
58DVA-17TA 11” to 17” pipe, adjustable
58DVA-24TA
17” to 24” pipe, adjustable
5DLA30 16.5” to 29” pipe , adjustable
5DLS1 1 7/8” to 9” slip length pipe
5DLS2 1 7/8” to 21” slip length pipe
58DVA-F6 6EFA 5DT-AF6 5DF Flashing, 0/12 to 6/12 roof pitch
58DVA-F12 6EFB 5DT-AF12 5DF12 Flashing, 7/12 to 12/12 roof pitch
58DVA-FF 6EF Flat Roof Flashings
58DVA-CFK 4MF Masonary Flashing