128 Presenting From a USB Drive, Camera, or CompactFlash Card
Transferring Your Scenario to a USB
Drive or CompactFlash Card
Once your scenario is saved, you can transfer it to a USB drive or
CompactFlash memory card. Be sure to use the transfer process
described below to ensure that the scenario plays properly:
1. Connect the USB drive. If you are using a CompactFlash card,
insert it in your computer or insert it in a card reader and connect
the card reader to your computer.
2. Start EMP SlideMaker 2 (see page 119).
3. Use the navigation tools in the folders window to locate the
scenario file you want to review. Click the file, then select
File > Open to open the scenario.
4. From the Scenario Option(s) menu, choose
Send Scenario.
You see a drive selection window:
5. Choose the drive (and folder) and click
OK.
6. Click
OK again to confirm. Your scenario is transferred to the
location you specified.
Once the scenario is transferred, you see this message about your
scenario’s autorun setting:
The autorun setting means that the scenario will start playing
whenever the projector is turned on (with the drive connected to
the projector).
note
Don’t use Windows to copy
the scenario to your USB
drive or memory card, or it
may not play properly.
You must connect the USB
drive (or card reader) before
you select
Send Scenario
from the Scenario Option(s)
menu. If you don’t, you
won’t be able to see the drive
in the drive selection
window. If this happens,
close and restart EMP
SlideMaker 2.
Select your
USB drive
To Next Page
Loading...
Need help?
General