Managing Projectors 167
Understanding the Notification Messages
If a projector experiences a problem, EMP Monitor sends an e-mail
message to each of the addresses you entered in the Set mail
notification function window.
The subject line of the message includes the projector’s display name,
shown in EMP Monitor, and the warning/error.
The body of the message contains:
■ The projector’s display name in EMP Monitor
■ The error/warning message
The problem descriptions are similar to the errors listed on page 162.
When the problem has been fixed, EMP Monitor sends a message
indicating the problem has been resolved.
Using a Browser to Monitor the
Projector
If your projector is connected to a network, you can use a standard
web browser to monitor and control it.
1. Make sure that the projector is set up for your network, as
described on page 61. (Standby Mode in the Extended menu
should be set to
Network On to monitor the projector in standby
mode.) When using a browser to access the projector, you cannot
connect through a proxy server.
2. Open your web browser and enter the IP address of the projector
you want to monitor in the browser window.
If you’re not sure what the address of the projector is, turn the
projector on and select
Wired LAN or Wireless LAN from the
Network menu to display the IP address of the projector.
note
If a projector develops a
critical problem, it may not
be possible for it to report the
error.
To Next Page
Loading...
Need help?
General