Solving Problems 193
■ If you’re using AirPort and DHCP is turned off on your
projector’s Access Point mode advanced settings screen, make sure
Distribute IP Addresses is off.
■ If you’re using Access Point mode and you’re connecting to the
wrong network, you may be experiencing signal interference from
another network. Try resetting your access point or base station,
then restart NS Connection.
■ If you’re using AirPort, the projector’s ESSID should match the
AirPort network name, not the name of the AirPort base station.
To check the network name, start the AirPort Admin utility,
select your base station, and click
Configure. Then click Show
All Settings
. The network name appears on the AirPort tab.
■ If you’re prompted for a password when you connect, enter the
WEP encryption key (if you’re using WEP encryption).
■ Try connecting using IP Connect Mode; see page 94.
Solving EasyMP Problems
An image displayed with EasyMP appears distorted.
Some high-resolution images cannot be displayed correctly. Files with
a high compression ratio may appear blurry. For BMP, GIF, and
PNG files, make sure the resolution is not greater than 1024 × 768.
For JPG files, the resolution must not be greater than 8192 × 6144,
and the image cannot be in progressive and CMYK color format.
In EMP SlideMaker, PowerPoint files don’t appear in the
file window.
EMP SlideMaker does not support PowerPoint 95 or 97. Files created
in these versions of PowerPoint must be opened and resaved in
PowerPoint 2000 or later.
To Next Page
Loading...
Need help?
General